MSe
Member
Hi,
Iam still struggling to get the multi state indicator in ftview me to work.
I have two states, 0 and 1. Each state makes use of an image. These images are shown depending on the value coming from the plc.
State 1 should be blinking. So I checked 'image blink' in the configuration. However the image is still show as 'steady' image.
How can I get this thing to work???
Thanks.
Iam still struggling to get the multi state indicator in ftview me to work.
I have two states, 0 and 1. Each state makes use of an image. These images are shown depending on the value coming from the plc.
State 1 should be blinking. So I checked 'image blink' in the configuration. However the image is still show as 'steady' image.
How can I get this thing to work???
Thanks.