I am working on developing a cabinet spec to eliminate the hodge-podge of random equipment installed on OEM machinery. i have put together the basics such as cpu type/size, color coding, wire marking, illuminated fused outputs, service laptop recep and workmanship. My question is does anyone know where i can find a site of infor on other spec used in industry. All of this has come about after we recieved a machine with a 5/05 processor, 14 Magnetek freq drive, 3 SEW freqs, Cutler Hammer touchscreen, banner proxes/photoeyes and telemechanique switches. In my mind since we had the beutiful AB 5/05 we should have had 160's and 1336plus drives and a panelview HMI.
the reason for the wire making specifics are as I:1/00 left the card it immediatly turned into TB100 in the panel then onto the next remote terminal block it became TB200 and again TB300 at the next and onto the device, this MESS makes it hard to troubleshoot without tugging wires and/or ringing them out.
could anyone point me in the correct direction? i dont want to miss anything and get a change order later when installintion begins.
thanks in advance, scott
the reason for the wire making specifics are as I:1/00 left the card it immediatly turned into TB100 in the panel then onto the next remote terminal block it became TB200 and again TB300 at the next and onto the device, this MESS makes it hard to troubleshoot without tugging wires and/or ringing them out.
could anyone point me in the correct direction? i dont want to miss anything and get a change order later when installintion begins.
thanks in advance, scott