jthornton
Member
Ok after reading the help file it says that if you latch a bit u must unlatch it with an OTU instruction...
What I am doing is to turn on a bit (latch it) if the trigger is present then the next scan do a bit shift then latch etc. All seems to work well when the bit shift fires the original bit B10:0/0 unlatches itself which is what I want to happen and the next bit B10:0/1 is now a one ala the bit shift left.
"In the event of a power loss, any OTL controlled output device will energize with the return of power if the OTL bit was set when power was lost." I'm doing a FLL on the Bits for the Bit Shift Left on the first scan so it should take care of this I hope... gotta go and test this...
Am I missing anything here???
Will it explode in my face someday???
It works in testing...
AB SLC 5/03
What I am doing is to turn on a bit (latch it) if the trigger is present then the next scan do a bit shift then latch etc. All seems to work well when the bit shift fires the original bit B10:0/0 unlatches itself which is what I want to happen and the next bit B10:0/1 is now a one ala the bit shift left.
"In the event of a power loss, any OTL controlled output device will energize with the return of power if the OTL bit was set when power was lost." I'm doing a FLL on the Bits for the Bit Shift Left on the first scan so it should take care of this I hope... gotta go and test this...
Am I missing anything here???
Will it explode in my face someday???
It works in testing...
[trigger]--[ons]---(BSL B10:0)
[trigger]----------(L B10:0/0)
AB SLC 5/03