Tim Ganz
Member
1.0 How do you et the control module apart from the power module? I see the clip on top but are you supposed to pull out toward you or slide up?
I can't seem to get it off and don't want to break anything. Is it just hard to remove?
2.0 is there only 1 control module (size for the entire power module range ( all Frames)?
3.0 is there any firmware or revision number between the control module and the power module so is a power module I order today going to work out of the box with a power module purchased the first days these were released? Or is there something to consider between them?
4.0 What is the lowest firmware you can set these up in the plc like the premier integration? THis would be on an L5 Processor. The processor has version 16 currently and I am not sure if the 525 will work with Logix firmware that old?
I can't seem to get it off and don't want to break anything. Is it just hard to remove?
2.0 is there only 1 control module (size for the entire power module range ( all Frames)?
3.0 is there any firmware or revision number between the control module and the power module so is a power module I order today going to work out of the box with a power module purchased the first days these were released? Or is there something to consider between them?
4.0 What is the lowest firmware you can set these up in the plc like the premier integration? THis would be on an L5 Processor. The processor has version 16 currently and I am not sure if the 525 will work with Logix firmware that old?