paulcamborne
Member
Hi
I have a 1511 plc and unidrive M300s communicating over profinet. I can start and stop and change speed ok but I cant workout how to change ramp parameters for example from a watch table.
I am using the SI profinet V2 on the drive for the comms.
Any ideas welcome
I have a 1511 plc and unidrive M300s communicating over profinet. I can start and stop and change speed ok but I cant workout how to change ramp parameters for example from a watch table.
I am using the SI profinet V2 on the drive for the comms.
Any ideas welcome