Hello,
confusion on the msg instruction configuration. We cannot find the target PLC-s in the communication path setup; however, we have made sure all the PlC-s are connected using rslinx classic and we can ping their ip address in the command line. Any advice on how to resolve this confusion would be greatly appreciated.
Software: Studio 5000 Logix Designer v31
PLC: Logix 5581E (2), Logix 5571, and EN2T
confusion on the msg instruction configuration. We cannot find the target PLC-s in the communication path setup; however, we have made sure all the PlC-s are connected using rslinx classic and we can ping their ip address in the command line. Any advice on how to resolve this confusion would be greatly appreciated.
Software: Studio 5000 Logix Designer v31
PLC: Logix 5581E (2), Logix 5571, and EN2T