Remote I/O in Softlogix

jomm

Member
J
Join Date
May 2010
Location
Makati
Posts
1
I just want try to communicate a Remote I/O to Softlogix. I already add and configure Ethernet communication module for Softlogix. I also clear the "accept UDP messages on ethernet port" in RSLinx. Still i got a communication timeout in ENBT module configured in the network.
Softlogix connection to ENBT.jpg
 

Similar Topics

Z
SCADA Pack RTU 474, IO card (5606) Not responding in Remote Connect
Hi, We have been facing a issue with SCADAPack 474. Configuration is like below. RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module Only...
Replies
0
Views
66
Zubairjaved786
Z
B
Recommendation for Expandible remote IO with OPC UA
Hello, Can anyone recommend an expandible IO module with OPC UA? I've deployed the Emerson RSTIO-OM module and it works great, but it has a...
Replies
0
Views
52
BeepBob
B
M
SCADA network extension to remote sites
So I'm pretty new around here but I come looking for advice or suggestions to research. Im the plant electrician/SCADA guy for a warer department...
Replies
8
Views
279
BeepBob
B
Cotafam
Addressing a Remote I/O Bit
See the screenshot of EIP tag list. We are trying to read in a digital input that is hard-wired. It is shown here as I31.1. I believe we cannot...
Replies
7
Views
302
Cotafam
Cotafam
T
Problem with remote control Compactlogic 35e
Hello Dear users, I am writing about a problem that has been bothering me for a few days, i.e. I am trying to establish remote access to the Allen...
Replies
0
Views
105
TOREK513
T
Back
Top Bottom