Baker in Virginia
Member
PowerFlex 525-Getting"Data Value Out of Range"when downloading in Drive Tab in 5000
Good Afternoon ,
I started a thread last week. I am using RS Logix 5000 with PowerFlex 525 drives. I am adding Output Current , Voltage , DC Bus Voltage , and Fault 1 Code , after clicking the "Change" button. I think I am doing this right. In the PowerFlex 525 Properties I am trying to download , within the Drive tab , to the PowerFlex 525 , and I keep getting a yellow bar , and a message " Data Value Out of Range ". I haven't seen any information on this. What could cause this ?
The steps , I assume , are to go offline, Click Change in the General Tab , make your selections in the "Drop Downs" , go to the Drive Tab , and download , correct ? Then I guess I download the entire application. I imagine I may have some issues with version , and IP address , correct ?
Thanks again for your help.
Good Afternoon ,
I started a thread last week. I am using RS Logix 5000 with PowerFlex 525 drives. I am adding Output Current , Voltage , DC Bus Voltage , and Fault 1 Code , after clicking the "Change" button. I think I am doing this right. In the PowerFlex 525 Properties I am trying to download , within the Drive tab , to the PowerFlex 525 , and I keep getting a yellow bar , and a message " Data Value Out of Range ". I haven't seen any information on this. What could cause this ?
The steps , I assume , are to go offline, Click Change in the General Tab , make your selections in the "Drop Downs" , go to the Drive Tab , and download , correct ? Then I guess I download the entire application. I imagine I may have some issues with version , and IP address , correct ?
Thanks again for your help.