Hardware:
HMI: PanelView Plus 1000
PLC: 1769-L32E
Software:
Logix 5000 rev 19
FT View Studio 6.10
Hello
Guys I am encountering a problem with Alarm messages. Whenever a fault or conditon occurs, I need a meesage to appear on my PV screen. Communications are set up properly and the everything works perfectly except an Alarm message when one needs to be displayed.
Here is what I have done:
I clicked "Startup" and checked Alarms and Information messages
I clicked "Alarm setup" and created Triggers by using tags and expressions for example: Silo_1 >= 90
Gave a value for the Trigger Silo_1 >= 90 Value: 90
Then I typed a message: Silo #1 Reaching Full Capacity
I checked "display" and used appropraite foreground and background colors for the message.
I then proceeded to advanced. At display, I chose the [ALARM] display to display Alarms when triggered.
..................................................................
From there I right clicked in the ALARM display and clicked properties. I then clicked Alarm from the properties window and looked at Filtering. I selected ALL Trigger Labels and applied this to my application.
I still can not trigger an Alarm to pop up on my PanelView whenever an alarm condition occurs.
Does anyone have any idea what I doing wrong or have any suggestions to find a solution.
Thanks
HMI: PanelView Plus 1000
PLC: 1769-L32E
Software:
Logix 5000 rev 19
FT View Studio 6.10
Hello
Guys I am encountering a problem with Alarm messages. Whenever a fault or conditon occurs, I need a meesage to appear on my PV screen. Communications are set up properly and the everything works perfectly except an Alarm message when one needs to be displayed.
Here is what I have done:
I clicked "Startup" and checked Alarms and Information messages
I clicked "Alarm setup" and created Triggers by using tags and expressions for example: Silo_1 >= 90
Gave a value for the Trigger Silo_1 >= 90 Value: 90
Then I typed a message: Silo #1 Reaching Full Capacity
I checked "display" and used appropraite foreground and background colors for the message.
I then proceeded to advanced. At display, I chose the [ALARM] display to display Alarms when triggered.
..................................................................
From there I right clicked in the ALARM display and clicked properties. I then clicked Alarm from the properties window and looked at Filtering. I selected ALL Trigger Labels and applied this to my application.
I still can not trigger an Alarm to pop up on my PanelView whenever an alarm condition occurs.
Does anyone have any idea what I doing wrong or have any suggestions to find a solution.
Thanks