br8veheart
Member
I have a Panelview 1000 (series a) that has a blank screen. I swapped the screen with a spare PV and it worked. I need to upload the program to my pc then download it to a replacement PV. This system was installed by contractors a few years ago and we do not have a copy of the pv program. I have installed Panelbuilder 32 on my laptop. I have connected with a serial cable and setup for DF1 communications. The problem is that I have an error identifing the PV. It says to check my cable, or make sure that the port (PV) isn't set to print. Unfortunately since the screen is blank I cannot get into configuration to ensure that the port is set correctly. Any help would be appreciated. My e-mail address is [email protected]