Hi all,
Have an issue at the moment. Currently setting up Kinetix 350 (V31-PR0-LM V 1.047) over Ethernet EN2T (V5.028)
When I go to the Tab to associate an axis - Logix (V20.01) L61 crashes every time I try to apply. I have tried setting up the axis prior to adding and creating new axis in the tab - same result each time. I've tried re-booting the PC - no joy. I did open another project with L36ERM and works fine. Is it a L61 issue or EN2T issue?
This has never happened before and I have set up plenty of them before, have not updated any software since the last time I set one up. I haven't contacted Rockwell yet, just thought I'd try here first.
Any thoughts?
Have an issue at the moment. Currently setting up Kinetix 350 (V31-PR0-LM V 1.047) over Ethernet EN2T (V5.028)
When I go to the Tab to associate an axis - Logix (V20.01) L61 crashes every time I try to apply. I have tried setting up the axis prior to adding and creating new axis in the tab - same result each time. I've tried re-booting the PC - no joy. I did open another project with L36ERM and works fine. Is it a L61 issue or EN2T issue?
This has never happened before and I have set up plenty of them before, have not updated any software since the last time I set one up. I haven't contacted Rockwell yet, just thought I'd try here first.
Any thoughts?