jolio ST
Member
Hello Guys.
I have a Prosoft 3150-MCM connected to a woodward MFR-15.
I got the MODBUS address from the supplier of woodward. The faults
I need to read from the MFR are as follow:
Engine active power - 40015
Engine reactive power - 40016
Earth fault - 40025:07
Over frequency - 40025:08
Over voltage - 40025:09
Loss of excitation -40025:10
I actually need an understanding on the RSLogix 500 program, how should I program to have the 3150-mcm read the modbus address from the woodward MFR? I only need an example of how the read command is done between the two device to give me a kick start.
Anyone here who has experience with this MFR and the modbus module to show me an example???
Thanks in advance!
regards
Sherine T.
Additional notes:
While I'm pondering on this, I also wonder if anyone who is familiar with WAGO PRO 32, as I am also having the same problem with the woodward MFR-15 to communicate with the WAGO PLC as I do not know how to program out the modbus function. This two projects are driving me bad, with just the MFR and the modbus communications. I really need someone to guide me out. Thanks!
I have a Prosoft 3150-MCM connected to a woodward MFR-15.
I got the MODBUS address from the supplier of woodward. The faults
I need to read from the MFR are as follow:
Engine active power - 40015
Engine reactive power - 40016
Earth fault - 40025:07
Over frequency - 40025:08
Over voltage - 40025:09
Loss of excitation -40025:10
I actually need an understanding on the RSLogix 500 program, how should I program to have the 3150-mcm read the modbus address from the woodward MFR? I only need an example of how the read command is done between the two device to give me a kick start.
Anyone here who has experience with this MFR and the modbus module to show me an example???
Thanks in advance!
regards
Sherine T.
Additional notes:
While I'm pondering on this, I also wonder if anyone who is familiar with WAGO PRO 32, as I am also having the same problem with the woodward MFR-15 to communicate with the WAGO PLC as I do not know how to program out the modbus function. This two projects are driving me bad, with just the MFR and the modbus communications. I really need someone to guide me out. Thanks!
Last edited: