bagged2drag
Member
I am working on a system with a siemens plc and HMI using TIA Portal V13 and WinCC. I wanted to remove to buttons from the HMI so the operator no longer has access to them. I removed them in the project (saved them on a temporary screen). When I uploaded the changes to the HMI, the buttons still exist. I also tried the simulator and I had the same results. Do I need to manually un-register the buttons somewhere?
Also, I made a new screen and changed one of the screen change buttons to direct toward it. When testing it, a blank screen showed up instead of the screen that I directed it to.
I have done a lot of plc/hmi programming in the past, but I have never experienced symptoms as such. Are there a lot of nuances with WinCC that I am unaware of?
Kris
Also, I made a new screen and changed one of the screen change buttons to direct toward it. When testing it, a blank screen showed up instead of the screen that I directed it to.
I have done a lot of plc/hmi programming in the past, but I have never experienced symptoms as such. Are there a lot of nuances with WinCC that I am unaware of?
Kris