OneDeadPixel
Member
Hello,
I'm an absolute newbie to the world of PLC's, and I'm currently using a DL05 with a F0-04AD-1 Analog Input Card, trying to take in 4-20mA output from several vibration sensors.
All I'm trying to do right now is follow the Analog Module manual's steps for setting up this particular module's V-memory locations on the DL05 as shown here:
I am able to create the [LD K8400] and [LDA O2000] instructions, but DirectSoft won't accept V7700 or V7701 for the output instructions.
I believe that I've got everything set up correctly, and I can see the Analog Card when I click Configure I/O, so I think it's being recognized. Does anyone have any ideas as to why the program won't allow me to utilize those memory locations?
Thanks for your assistance!
I'm an absolute newbie to the world of PLC's, and I'm currently using a DL05 with a F0-04AD-1 Analog Input Card, trying to take in 4-20mA output from several vibration sensors.
All I'm trying to do right now is follow the Analog Module manual's steps for setting up this particular module's V-memory locations on the DL05 as shown here:
I am able to create the [LD K8400] and [LDA O2000] instructions, but DirectSoft won't accept V7700 or V7701 for the output instructions.
I believe that I've got everything set up correctly, and I can see the Analog Card when I click Configure I/O, so I think it's being recognized. Does anyone have any ideas as to why the program won't allow me to utilize those memory locations?
Thanks for your assistance!