hi....guys...i am using PL7 junior v4.3 software for TSX MICRO PLC -MODICON MAE ..can u guys suggest me how to establish communication betwenn PLC and pc?..i tried but failed to communicate .i am using TSXPCX1031 cable for communication. error showing is NOT POSSIBLE TO ESTABLISH PHYSICAL LINK WITH PLC ADDRESS SYS VIA DRIVER UNTLW01...........
Pc and plc coomunication problem
- Thread starter niyaz432
- Start date
Similar Topics
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
the conveyor can stop because of a safety sensor or safety switch. And also it can stop because of an object jam detector sensor. If the conveyor...
Good Day to all of you, this is my first post, i will try to explain as best as possible, english is not my natural language. I am performing an...
Hi All,
Someone at work has put a PLC system on my desk, that's just been taken off an idle production line.
He said "It's an S7 PLC. We don't...
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...