forqnc
Lifetime Supporting Member
Hi all,
Working in RSLogix 500, everything was/is going good except a couple of timers won't accept the symbol editor name I put in. It appears for some reason to be because of the address being shown and grayed out. See attached pictures. The red scribble line is where I type my name but below that the address shows up. On addresses that work OK, the address is not shown. Tried a search of the forum but guess I not getting the right key words.
Any help is appreciated.
Working in RSLogix 500, everything was/is going good except a couple of timers won't accept the symbol editor name I put in. It appears for some reason to be because of the address being shown and grayed out. See attached pictures. The red scribble line is where I type my name but below that the address shows up. On addresses that work OK, the address is not shown. Tried a search of the forum but guess I not getting the right key words.
Any help is appreciated.