EICS
Member
has anyone known of a gateway to bridge between a Bailey Infi 90 DCS and a Rockwell Control Logix 1756-L83 CPU successfully?
i believe there is a product called a GPI (General Purpose interface) or HGS (Harmony Gateway Solution) to bridge the 2 devices via some kind of point table in the device?
My Bailey Infi 90 DCS has the following if it helps
- 2 Only BRC300 CPU's in redundant pair mode
- 3 Only CIU01's ( Infi-net to Serial for EWS and Scada servers)
- NPM's etc
i want to set up a bridge to communicate between and existing DCS and 3 or more New Rockwell 1756CPU's.
i am located in Australia and hoping someone in USA has known if this has been done successfully.
any info on protocols etc is handy.
i believe there is a product called a GPI (General Purpose interface) or HGS (Harmony Gateway Solution) to bridge the 2 devices via some kind of point table in the device?
My Bailey Infi 90 DCS has the following if it helps
- 2 Only BRC300 CPU's in redundant pair mode
- 3 Only CIU01's ( Infi-net to Serial for EWS and Scada servers)
- NPM's etc
i want to set up a bridge to communicate between and existing DCS and 3 or more New Rockwell 1756CPU's.
i am located in Australia and hoping someone in USA has known if this has been done successfully.
any info on protocols etc is handy.
Last edited: