naturephoenix
Member
Hello guys, I got 6 PLCs with in same network for example 10.80.x.x
One of these PLCs is S71200 which I'm trying to use as RTU, its IP address is 10.80.0.1.
On this s71200 PLC I put DNP3 module but I keep it in another network 192.168.100.1.
Ths DNP3 module needs to communicate with SCADA telecontrol center. SCADA master/partner is in 192.168.x.x network.
My question is whether I will be able to read/send data from S71200 PLC to my DNP3 module since they are not in same network?
One of these PLCs is S71200 which I'm trying to use as RTU, its IP address is 10.80.0.1.
On this s71200 PLC I put DNP3 module but I keep it in another network 192.168.100.1.
Ths DNP3 module needs to communicate with SCADA telecontrol center. SCADA master/partner is in 192.168.x.x network.
My question is whether I will be able to read/send data from S71200 PLC to my DNP3 module since they are not in same network?