Hi all.
I have an application to apply but i have been using RSlogix Emulate to pre-code my application and would like if someone correct me if i am wrong.
Application operation is very simple.
components: 2 leds (Yellow & Green)- two push buttons - 1 motor - limit switch
1- two buttons backward and forward
2- when backward is pressed a yellow LED light is on until it reach home position then yellow is off and green is on
i need to include limit switch but i dont know how!!
3- when forward is pressed, yellow turns on until it reach final point then then green turns on
Code:
backward driver cw ---------- yellow led
---][--------]/[-------------------()--
yellow led----------------------- Motor
---][------------------------------()--
Motor -------------------------Green led
---][------------------------------()--
Green led ---------------------yellow led
---][------------------------------(U)
same for forward - is that correct one to start with?
I have an application to apply but i have been using RSlogix Emulate to pre-code my application and would like if someone correct me if i am wrong.
Application operation is very simple.
components: 2 leds (Yellow & Green)- two push buttons - 1 motor - limit switch
1- two buttons backward and forward
2- when backward is pressed a yellow LED light is on until it reach home position then yellow is off and green is on
i need to include limit switch but i dont know how!!
3- when forward is pressed, yellow turns on until it reach final point then then green turns on
Code:
backward driver cw ---------- yellow led
---][--------]/[-------------------()--
yellow led----------------------- Motor
---][------------------------------()--
Motor -------------------------Green led
---][------------------------------()--
Green led ---------------------yellow led
---][------------------------------(U)
same for forward - is that correct one to start with?
Last edited: