I could use some advice before I get to far along with a project. I would like to connect a panelmate 1500 to a micrologix 1000. I am totally new to working with HMI programming. I installed the panelview configuration software (power series) and transfer utilities. I also have a
"Panelmate Power Series Allen-Bradeley Driver Disc" and
"Panelmate Compact SLC-500 Option disk"
I have not loaded these because there is a note that came in the box that states that once the DH-485 driver is loaded it can not be removed and no aditional installs will be possible.
Will I be necessarilly using DH-485 to talk to a Micrologix 1000?
If not maybe I should not load it at all.
Do you think the one load warning applies to both disks or just the disk marked SLC-500 Option. If I do load them am I loading them on the HMI or the computer because if I only have one load I may want to use my computer at work before I practice at home. Thanks [email protected]
"Panelmate Power Series Allen-Bradeley Driver Disc" and
"Panelmate Compact SLC-500 Option disk"
I have not loaded these because there is a note that came in the box that states that once the DH-485 driver is loaded it can not be removed and no aditional installs will be possible.
Will I be necessarilly using DH-485 to talk to a Micrologix 1000?
If not maybe I should not load it at all.
Do you think the one load warning applies to both disks or just the disk marked SLC-500 Option. If I do load them am I loading them on the HMI or the computer because if I only have one load I may want to use my computer at work before I practice at home. Thanks [email protected]