Due to all the recent icing from the great winter weather this past week we have experienced many power glitches. reaking havoc on our drive and plc systems. 1 occurance with the slc 5/05 remote I/O. A system with 6 surge tanks with level control. first2 were reading tank weight ok. last four
had lost weight. no longer transfering data. after toggeling to prgm back to run every thing was fine. Except while reading
0 weight the fill valve opened or was open when it locked
up and overflowed there is a high high level sensor which
was working. but did not close the valva as programmed.
My question is if a remote rack locks up
does the Flex RIO Reset to zero or maintain last state
and is this set in the ASB.?????
had lost weight. no longer transfering data. after toggeling to prgm back to run every thing was fine. Except while reading
0 weight the fill valve opened or was open when it locked
up and overflowed there is a high high level sensor which
was working. but did not close the valva as programmed.
My question is if a remote rack locks up
does the Flex RIO Reset to zero or maintain last state
and is this set in the ASB.?????