Hi I have a 1784-IE8C which is configured for 4-20mA input, high engineering is 16383 and low enginering is 3277
The raw value from this channel is being read as -8. The scaling blow is 0-272 RPM but is showing -65.6 due to the -8
I have not done any trouble shooting yet so was looking for advice. I was going to connect 4mA from a calibrator and see what it read
I would say the card should read 3277 at 4mA so is -8 likely to be broken wire/under range?
I am on site tomorrow so can check diagnostics
The raw value from this channel is being read as -8. The scaling blow is 0-272 RPM but is showing -65.6 due to the -8
I have not done any trouble shooting yet so was looking for advice. I was going to connect 4mA from a calibrator and see what it read
I would say the card should read 3277 at 4mA so is -8 likely to be broken wire/under range?
I am on site tomorrow so can check diagnostics