Allen campbell
Member
I have a question about config this Input Module. I'm using a SLC 5/05 and trying to config inputs 5-8. Inputs 0-4 have been done. In the advanced I/O configuration set up I check Channel Enable,Temp units C, Data Format Engineering Units x10.for channel 5-8. Then click OK then I get a Configuration Rung and Data (rung to be inserted) but online the Length on the COP is still a 4. There is a first pass xio then the COP.
Do I have to cycle power to get the 4 to a 8
Do I have to cycle power to get the 4 to a 8