well to display an SQO statement you right click on the statement goto display special. These should match up to your outputs in a bit fashion. I see that you are using (if I read the I/O structure correct.)
O:0=blower out 1
0:1=airlock out 1
O:2=outside blower
O:3=appears to be unused correct?
O:4=blower out 2
O:5=airlock out 2
O:6=not used auger out 2
O:7=alarm light.
now I understand you want to add another alarm light correct?
on Inputs you have
I:0=start system 1
I:1=stop pb 1
I:2=start system 2
I:3=stop pb2
I:4=airlock 1 senser
I:5 auger 1 not connected.
I:6airlock 2 senser
I:7auger 2 senser not connected.
plz advise if I missed any I/O's and if these are correct.
O:0=blower out 1
0:1=airlock out 1
O:2=outside blower
O:3=appears to be unused correct?
O:4=blower out 2
O:5=airlock out 2
O:6=not used auger out 2
O:7=alarm light.
now I understand you want to add another alarm light correct?
on Inputs you have
I:0=start system 1
I:1=stop pb 1
I:2=start system 2
I:3=stop pb2
I:4=airlock 1 senser
I:5 auger 1 not connected.
I:6airlock 2 senser
I:7auger 2 senser not connected.
plz advise if I missed any I/O's and if these are correct.