Wth regards to Rons earlier post concerning the destinations being the same you can easily set SQO n12:10's destination top O:0.1
SQO n12:20 to O:0.2
SQO n12:30 to O:0.3
however you should only have to set n12:20 and n12:30 to O:0.1
this should allow you to run both systems independantly. as it was the n12:20 and n12:30 destinations was overwriting the destination address on n12:0 and n12:1
you will also need to clear destination O:0.1
this is done for destination O:0.0 on rung 000 ladder 2,
SQO n12:20 to O:0.2
SQO n12:30 to O:0.3
however you should only have to set n12:20 and n12:30 to O:0.1
this should allow you to run both systems independantly. as it was the n12:20 and n12:30 destinations was overwriting the destination address on n12:0 and n12:1
you will also need to clear destination O:0.1
this is done for destination O:0.0 on rung 000 ladder 2,
Last edited: