Good afternoon all.
I've been tasked in getting a 2711R-T4T PanelView 800 4.3” communicating with a AB SLC5/03 PLC.
This was a system which was working in the past with another HMI (which stopped working) and the 2711R-T4T PanelView 800 4.3” is its replacement.
The top channel 1 RJ45 port is used for comms with an Intouch Scada network.
So I will be using the bottom Channel 0 RS232 port for comms with the panelview.
Before I go to site and investigate, I want to check about the correct cable.
I have the following two cables and wondering if they are suitable.
1. 1756CP3/A I'm pretty sure this cable is ok, but its my own programming cable and I need it.
2. 1761 CBL-AC00 SER.A AIC To Controller Comms Cable, very short but may work.
Any help or advice would be greatly appreciated.
Regards Padraic.
I've been tasked in getting a 2711R-T4T PanelView 800 4.3” communicating with a AB SLC5/03 PLC.
This was a system which was working in the past with another HMI (which stopped working) and the 2711R-T4T PanelView 800 4.3” is its replacement.
The top channel 1 RJ45 port is used for comms with an Intouch Scada network.
So I will be using the bottom Channel 0 RS232 port for comms with the panelview.
Before I go to site and investigate, I want to check about the correct cable.
I have the following two cables and wondering if they are suitable.
1. 1756CP3/A I'm pretty sure this cable is ok, but its my own programming cable and I need it.
2. 1761 CBL-AC00 SER.A AIC To Controller Comms Cable, very short but may work.
Any help or advice would be greatly appreciated.
Regards Padraic.