Hi,
I have a question outside the plc area, but I thought someone would have an idea.
I was comissioning an ABB ACS355 drive (frequency inverter) with Basic-panel. I entered parameters and tried to manually operate the drive to check the rotation of the motor. When I pressed start button, the drive gives F0016 (earth fault). I checked the motor's and cable's insulation, they're ok. I tried to start drive without motor cable connected and it gave the same fault code.
We discussed with ABB and they said it's warranty issue, so we got a new drive. But it didn't help. New drive gives the same fault code. User manual says that you can disable the earth fault monitoring, but you might lose the warranty by doing that.
Then I had to power up and parametrize ACS 355 drive on different work cite and it runs fine.
So long story short, does anyone had these kind of problems with drives?
I have a question outside the plc area, but I thought someone would have an idea.
I was comissioning an ABB ACS355 drive (frequency inverter) with Basic-panel. I entered parameters and tried to manually operate the drive to check the rotation of the motor. When I pressed start button, the drive gives F0016 (earth fault). I checked the motor's and cable's insulation, they're ok. I tried to start drive without motor cable connected and it gave the same fault code.
We discussed with ABB and they said it's warranty issue, so we got a new drive. But it didn't help. New drive gives the same fault code. User manual says that you can disable the earth fault monitoring, but you might lose the warranty by doing that.
Then I had to power up and parametrize ACS 355 drive on different work cite and it runs fine.
So long story short, does anyone had these kind of problems with drives?