TIA5000
Member
Hello everyone,
I face a problem with setting connection between my computer and PLC using NAT addressing.
I configured NAT. In private network it's everything fine.
When I am connected to public side of my network I can:
* use VNC viewer to control my PVP HMI
* open NAT configuration webserver
* ping NAT, HMI and PLC (devices with assigned mapping) using cmd.
What I cannot do in a public network:
* find this devices in RSLinx
* connect to the PLC using Studio5000
Do you know where the problem is?
I assume either in NAT config or in RSLinx adapter settings.
I face a problem with setting connection between my computer and PLC using NAT addressing.
I configured NAT. In private network it's everything fine.
When I am connected to public side of my network I can:
* use VNC viewer to control my PVP HMI
* open NAT configuration webserver
* ping NAT, HMI and PLC (devices with assigned mapping) using cmd.
What I cannot do in a public network:
* find this devices in RSLinx
* connect to the PLC using Studio5000
Do you know where the problem is?
I assume either in NAT config or in RSLinx adapter settings.