Ok so first allow me to bow my head and say I'm a retired mechanical engineer and while I still have a few brain cells left there is something I think I'm missing in the setup.
I have 2 Ultra3000 servo drives and 2 Mpl servo's. Regardless of the combination I'm getting the E11 error which has to do with the phasing not being correct. I've double checked the wiring harnesses and changed the orientation of UVW. Nope, nothing helps. Both of the drives are used but appear to be in operational condition (I have no direct history on them).
I have not tried to communicate with the drives through any program. This is where I'm falling short. Could the drives been programmed previously so that they don't recognize the servo's? Any suggestions would be greatly appreciated.
John
I have 2 Ultra3000 servo drives and 2 Mpl servo's. Regardless of the combination I'm getting the E11 error which has to do with the phasing not being correct. I've double checked the wiring harnesses and changed the orientation of UVW. Nope, nothing helps. Both of the drives are used but appear to be in operational condition (I have no direct history on them).
I have not tried to communicate with the drives through any program. This is where I'm falling short. Could the drives been programmed previously so that they don't recognize the servo's? Any suggestions would be greatly appreciated.
John