joemev
Member
Good Evening,
I am an under graduate engineering student presently working on a project involving the Mitsubishi FX3G PLC.
I plan to programme the PLC using GX developer.
At present I only have one Analogue input I wish to input to the PLC and I will be doing this through the use of a Special Function Block (Mitsubishi FX2N-4AD)
The input will be a simple voltage input of -10 to +10 Volts.
I have referred to the relevant manuals and so far I have came up with the following ladder logic:
----|M1|------[TO K0 K0 H3330 K2]--------
|
|
--[FROM K0 K10 D10 K2]-------
Can anyone advise as to their thoughts on what I have so far produced.
The idea behind the system is to obtain a value from the A/D converter and then put together a HMI design that could then utilise the information.
Any help would be greatly appreciated.
Thank You in advance.
Joe
I am an under graduate engineering student presently working on a project involving the Mitsubishi FX3G PLC.
I plan to programme the PLC using GX developer.
At present I only have one Analogue input I wish to input to the PLC and I will be doing this through the use of a Special Function Block (Mitsubishi FX2N-4AD)
The input will be a simple voltage input of -10 to +10 Volts.
I have referred to the relevant manuals and so far I have came up with the following ladder logic:
----|M1|------[TO K0 K0 H3330 K2]--------
|
|
--[FROM K0 K10 D10 K2]-------
Can anyone advise as to their thoughts on what I have so far produced.
The idea behind the system is to obtain a value from the A/D converter and then put together a HMI design that could then utilise the information.
Any help would be greatly appreciated.
Thank You in advance.
Joe