Input analog FX2N8AD to output analog FX2N2DA - mitsubishi

vinicius_MPA

Member
V
Join Date
Jan 2016
Location
Brazil
Posts
1
Hi everyone, so I'm learning about Mitsubishi, I read the manuals about these modules, and I understand a little, I need control a proportional valve.the input module will receive the signal from the linear potentiometer , and the output module will send the signal to the porportional valve. So I know that the value is registered at a data value (channel1 = D0), Can I take this value and put at the D100 in example program output module? excuse me for my ignorance , I began to learn yesterday and already my boss gave me this challenge. thanks to everyone who can help me

fx2n2da.png fx2n8ad.jpg
 

Similar Topics

K
Input Analog Jittering
I'm having trouble calming down 2 Tempo Sonics. I'm using Studio 5000 CompactLogix my Raw value is jumping around from 8575.0 to 8755.0 at a...
2 3
Replies
30
Views
1,154
Peter Nachtwey
Peter Nachtwey
U
SLC500 analog input value data type for EZ Series HMI
I cannot add SLC500 analog input tag (I: 8.3) to EZSeries Touch Panel Editor (V 5.3). I used all the listed tag datatype but it all says "Invalid...
Replies
10
Views
264
OkiePC
OkiePC
K
How to add Analog Input into Ignition Designer
Hi, I have questions. I have Analog Input that need to put into Ignition Designer. But I don't know how to put?
Replies
1
Views
129
Old Man
O
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
96
Ko Lin
K
A
AMI0800 Analog Input Module's I/O LED is Lighting up red
Why AMIo800 Analog input module's I/O LED is Lighting up Red? Checked module connections, 4-20ma wires etc but this light is continuously Lighting...
Replies
1
Views
114
nicherbert
N
Back
Top Bottom