TheWaterboy
Lifetime Supporting Member + Moderator
I got an ANC-100e DH+ gateway for some remote work via Cell modem. It works fine and I can program the PLC5 on the far end just fine, but I can't figure out how to construct a MSG path from a CLX using this thing? How do you address the node after the IP address?
I have a somewhat similar Prosoft device that you just add a comma and the node address after the IP address, but I can't find any doc on this ANC-100e device on this subject .
I have a call into their support but they don't open for another hour. I'm hoping someone here has this answer .
I have a somewhat similar Prosoft device that you just add a comma and the node address after the IP address, but I can't find any doc on this ANC-100e device on this subject .
I have a call into their support but they don't open for another hour. I'm hoping someone here has this answer .