I_Automation
Lifetime Supporting Member
Ok i see.
I understand on the electrician end how this is not allowed. How about machine specific work? Or should i say anything after the disconnect/main CB, on any particular machine or system. Mainly under 125A machines.
You can run a power cord from your machine into a service disconnect, conduit no. And Sealtite would be a grey area here. Just make sure you don't take any shortcuts and make it look professional.
Once the power is in your machine (distribution block or disconnect) then it's all yours.
One thing about the union shops I go into is their electrician runs ALL power, even connects your power cable into his service disconnect, all you have to do is sit around 3 or 4 hours for him to show up and do it.