Autotuning Sinamics G120

Plc_User

Member
P
Join Date
Dec 2005
Location
Belgium
Posts
317
In the past I had some difficulties autotuning Sinamics G120 drives if long motor cables (>80m) and output chokes were used.
This resulted in a failed autotuning proces, so I had to use U/F mode.
Does someone has experience in this situation?
Are there tricks to let the autotune succeed, or is there a way to manualy setup the right vector control parameters?

Thanks
 

Similar Topics

A
PIDE Autotuning for Level Control
Have a logix controller and I'm using the PIDE block for the autotuner. I've got the hang of doing it for direct control things like pressure...
2
Replies
21
Views
1,835
drbitboy
drbitboy
A
Hpmont PLC- Pid instruction autotuning is not working
Hello, there is anyone who have already used hpmont plc? now i am programming for that plc and have " pid autotuning is not working" issue. I have...
Replies
0
Views
985
arkar
A
2rlp
VFD Autotuning
I have used a lot of VFDs ranging from ABs 1336Impact, Yaskawa's G5 and currently A1000 series on hoists and other lifting applications. These...
2
Replies
18
Views
4,847
Peter Nachtwey
Peter Nachtwey
U
autotuning servo motor
I am autotuning a servo motor (with Kinetix 300) using Motionview Onboard. #1) About autotuing's travel limit. I don't know what it is. When...
Replies
2
Views
2,305
Peter Nachtwey
Peter Nachtwey
R
AB Kinetix 6000 Autotuning Errors
Hi there, First off, any help/suggestions to resolve these issues is greatly appreciated. My drive configuration and servo tuning experience is...
Replies
8
Views
8,612
kekrahulik
K
Back
Top Bottom