Hello everyone!
I was wondering if you could help me with something i'm trying to do solve.
The situation: there are an old machine with stepper motors Weiss SF75.
The motors connected to with Ecostep controllers, and these are managed by B&R 474 PLC via Canbus.
I have to change some moving coordinates of the motors.
I have tried to connect to PLC with the following options without success:
- Original serial port on the laptop (tested, it is ok)
- Weis SH75 software (it is ok, get from Weiss company)
- Serial cable (it is ok, tested on other machine)
- PVI Monitor trial version
I really do not know why I can not communicate with the PLC.
Have somebody any idea what can I try?
Thanks in advance!
I was wondering if you could help me with something i'm trying to do solve.
The situation: there are an old machine with stepper motors Weiss SF75.
The motors connected to with Ecostep controllers, and these are managed by B&R 474 PLC via Canbus.
I have to change some moving coordinates of the motors.
I have tried to connect to PLC with the following options without success:
- Original serial port on the laptop (tested, it is ok)
- Weis SH75 software (it is ok, get from Weiss company)
- Serial cable (it is ok, tested on other machine)
- PVI Monitor trial version
I really do not know why I can not communicate with the PLC.
Have somebody any idea what can I try?
Thanks in advance!