oceanwanderlust
Member
Hello All,
I am just trying to get my first ladder program to do anything...
I'm using an Omron CQM1 CPU21 w/ CxOne CxProgrammer 6.0
My first try is a simple counter which counts 10 seconds then resets itself. No point really, just seemed like a good starting place.
LD P_1s
LD CNT011
CNT 011 #10
However when I run this program in CxProgrammer, none of the values in the graphical CNT change and I never see CNT011 become true.
My next unrelated try was to increment a memory location every second.
LD P_1s
@INC(38) DM6
However, again the value in the graphical INC does not change, and neither does DM6 when viewed in the Omron Data Monitor Component.
I must really be missing something here...
any help would be appreciated
joe
I am just trying to get my first ladder program to do anything...
I'm using an Omron CQM1 CPU21 w/ CxOne CxProgrammer 6.0
My first try is a simple counter which counts 10 seconds then resets itself. No point really, just seemed like a good starting place.
LD P_1s
LD CNT011
CNT 011 #10
However when I run this program in CxProgrammer, none of the values in the graphical CNT change and I never see CNT011 become true.
My next unrelated try was to increment a memory location every second.
LD P_1s
@INC(38) DM6
However, again the value in the graphical INC does not change, and neither does DM6 when viewed in the Omron Data Monitor Component.
I must really be missing something here...
any help would be appreciated
joe