[email protected]
Member
Hello
i am having 3 problems in mapping singals from my program to the physical i/o modules of the PLC. i can mapp digital i/o no problem its just the analog ones are causing me alot of bother!
1. first of all i am not sure where i wire the count from my encoder to the KL5111 module. when i give it a few pulses into the "A" connection nothin happens??
2. also my KL4408 module seems to have all its LED indicators lit when i put the plc in run mode and it will not give a 0 - 10V signal when i force it wihtin the PLC?
3. more importantly i cant seem to get the CX9001 to recogininse the EL3012 module. i dont have the option to add an "EL" modules in the system manager of twincat.
my CX9001 has a K-Bus as far i know and i am wondering if the EL3102 is not compatable as i think it uses the E-bus?
thanks
i am having 3 problems in mapping singals from my program to the physical i/o modules of the PLC. i can mapp digital i/o no problem its just the analog ones are causing me alot of bother!
1. first of all i am not sure where i wire the count from my encoder to the KL5111 module. when i give it a few pulses into the "A" connection nothin happens??
2. also my KL4408 module seems to have all its LED indicators lit when i put the plc in run mode and it will not give a 0 - 10V signal when i force it wihtin the PLC?
3. more importantly i cant seem to get the CX9001 to recogininse the EL3012 module. i dont have the option to add an "EL" modules in the system manager of twincat.
my CX9001 has a K-Bus as far i know and i am wondering if the EL3102 is not compatable as i think it uses the E-bus?
thanks