PLC Pie Guy
Member
Morning all.
I am trying to finish up my Micro820 project and I found a couple of silly things over the weekend.
One is this. I attached a screen shot to show that I am trying to simply move a branch to parallel some instructions. The trouble is that the whole branch moves. Not just one side of it. I can drag it all over the ladder rung but I can't seem to get the points of contact where I need them.
Is there some sort of dance I have o do to make this go where I want?
Something silly once again, I can tell.
Its almost embarrassing to post such a question but any other PLC I would simply drag the connection points to their desired location.
Thanks
I am trying to finish up my Micro820 project and I found a couple of silly things over the weekend.
One is this. I attached a screen shot to show that I am trying to simply move a branch to parallel some instructions. The trouble is that the whole branch moves. Not just one side of it. I can drag it all over the ladder rung but I can't seem to get the points of contact where I need them.
Is there some sort of dance I have o do to make this go where I want?
Something silly once again, I can tell.
Its almost embarrassing to post such a question but any other PLC I would simply drag the connection points to their desired location.
Thanks