I have a Point defined in Cimplicity 8.1 as follows.
Point Name: TESTBOOL
Data Type: BOOL
Device ID: GEPLC
Address: %M100
The device being communicated to is a GE Series 90-30 PLC.
When I display the value of TESTBOOL, instead of displaying a 0 or 1 depending on the state of bit %M100 it displays an integer representing the binary value of bits %M100, %M101, %M102, etc.
Very strange. Any ideas?
Point Name: TESTBOOL
Data Type: BOOL
Device ID: GEPLC
Address: %M100
The device being communicated to is a GE Series 90-30 PLC.
When I display the value of TESTBOOL, instead of displaying a 0 or 1 depending on the state of bit %M100 it displays an integer representing the binary value of bits %M100, %M101, %M102, etc.
Very strange. Any ideas?