Cognex vc5 vision controller

cty1002001

Member
C
Join Date
Nov 2011
Location
Kentucky
Posts
1
Good Morning,
I have had a problem come up with a project that completed 3 months ago with a L71s Allen Bradley controllogix platform and a Cognex VC5 3d vision controller. All of a sudden I have lost communications on my Ethernet line from the plc to the vision controller. I can ping the IP address but RS linx will not see it. Contacted AB and Cognex and other than updating the firmware for the EN2T they are not sure what has happened, also I had the Ethernet cables changed out just in case.
Any Thoughts,
Thanks,
Chris
 

Similar Topics

E
Cognex dataman 280 barcode reader input to rslogix 5000
Hello, I am trying to read a barcode scanner input using a cognex dataman 280 barcode reader, store it another string, the compare with another...
Replies
1
Views
64
Emmabod
E
croakus
Re-purpose a Cognex Sensorview monitor
We finally replaced our Cognex Checker with an IV-3 and I'm wondering if can replace the s/w in the monitor with anything else. I haven't been...
Replies
0
Views
107
croakus
croakus
J
RSLogix 5000 and Cognex In-Sight Explorer 5.9 - Will not Read/Write data
Thank you for any and all responses/help. I have an RSLogix 5000 v20 and a Cognex In-Sight v5.9 spreadsheet (8502P). I can not figure out how to...
Replies
0
Views
142
JEM
J
H
Siemens S7-1200 communication with Cognex 2800
Which signals do I have to use to get data from camera. For example camera detects a defect and sends signal to controller. Power cable: CCB-PWRIO-05
Replies
1
Views
228
Puddle
P
B
Cognex- How to record images with graphics
Good People of PLCTALK. I am trying to understand the pass-fail on one of our product lines. I was able to record the Cognex images on the...
Replies
2
Views
248
bdauliya
B
Back
Top Bottom