Commissioning Sinamics V90 Starterspakket

mulderm

Member
M
Join Date
Jun 2003
Location
Netherlands
Posts
298
Hello, After commissioning the V90 starterpakket follow siemens commissioning file: 109743917_Standard_Application_V90pn_S7_1200_PositionControl_DOC_en_V1.1.pdf, i get by commissioning the fault: "Error in target range" see attachment. Also strange I see no selector encoder on drive as mentioned in the Application pdf.See attachment.Normaly I expected also 2500 p/rev of the encoder but see low values.I use Tia Portal V17. Can comebody help me? Thnx.

Encoder on profinet.jpg Encoder.jpg
 

Similar Topics

B
Commissioning Powerflex IP addresses
I have to commission about 150 drives next week. The last couple times, I just used the BootP/DHCP tool. For anyone coming across this and...
Replies
10
Views
2,648
Brew Chip
B
Dayvieboy
Decommissioning soon
These were here when I showed up in 1991 ... 31 years ago Allen Bradley SLC 100. .. Programmed with a hand loader Allen Bradley PLC 5/20 ... I...
2
Replies
19
Views
4,724
LadderLogic
LadderLogic
EStufC
Commissioning plc communiccation block for a connection with VFD
Hello everyone, Currently I am performing preparations for a huge project. And there is a need to establish communication between plc and VFD by...
Replies
2
Views
1,282
EStufC
EStufC
J
Mitsubishi FR-V500 (3.7Kw) Commissioning
Hi, I am commissioning a Mitsubishi FR-V500 (3.7Kw) drive. I am able to get the drive to tune and spin up if I set parameter (Pr) 800 = 20 (V/F...
Replies
2
Views
1,347
jets
J
Z
SLC 5/05 Commissioning Troubles
Hi all, I have a SLC 5/05 (1747-L552 B 4) that I've been tasked with recycling for use on another part of this factory. The device is connected...
Replies
5
Views
1,781
JaxGTO
JaxGTO
Back
Top Bottom