Hope everyone had a good Thanksgiving Holiday.
I am getting ready to purchase a used machine. This machine was
built in 1990. It has a Omron Sysmac C20 PLC ,and I have a few
questions:
Is the software still available ?
Have you seen any pinout's for
communication cables ?
I searched for "Omron Sysmac C20 PLC" there were few threads,
but were a few years old.If I can get the program off of it,
I would like to change out the plc.
Thanks in advance,
I am getting ready to purchase a used machine. This machine was
built in 1990. It has a Omron Sysmac C20 PLC ,and I have a few
questions:
Is the software still available ?
Have you seen any pinout's for
communication cables ?
I searched for "Omron Sysmac C20 PLC" there were few threads,
but were a few years old.If I can get the program off of it,
I would like to change out the plc.
Thanks in advance,