communication betwen cpu103 and no SIMATIC panel

aymen

Member
A
Join Date
Mar 2009
Location
tunis
Posts
11
I just want to know if i should use special standard function bloc to communicate betwen S5 -cpu103 and no-SIMATIC panel usig AS511 protocol?
as i know we should use FB51 (TDOP:511) to communicate with SIMATIC panel.

best regards.
 
It depends on the panel that you will be using, if you happen to use a ESA-vt panel then it does not require any function blocks.
 

Similar Topics

D
communication betwen 1761-NET-ENI AND 1761-NET-AIC
Hello, currently I have a micrologix 1200 (1762-L40AWAR )connected to an HMI panelview 600(2711-T6C3L1X) via the 1761-net-aic module, I want to...
Replies
13
Views
1,800
driverx
D
J
Communication betwen Twido TWDLCAE40DRF AND SIX (6) HMISTU855
HELLO I have a situation with one PLC twido TWDLCAE40DRF and six (6) HMISTU855; the configuration is shown in the attached. The situacion is...
Replies
4
Views
1,803
jalejorv4
J
A
communication problem betwen cpu928 and PC (supervisor) using ethernet
hello i think the cause of this communication failure is the erase of communication processor 6gk1143-0ta02. i have the data base but i dont know...
Replies
0
Views
2,950
aymen
A
C
SLC 5/03 Communication / Processor Issue
Hello All! I am writing today because I cannot figure this out for the life of me. Another site I am affiliated with keeps having their slc 5/03s...
Replies
10
Views
106
geniusintraining
geniusintraining
A
Communication Issues between PowerFlex 700 and M580 Controller
Hello, I am currently in the final week of my internship and I have encountered issues with communication between a PowerFlex 700 variable...
Replies
0
Views
41
asmer
A
Back
Top Bottom