Communication Microwin with Radio Modems

robertopsilva

Member
R
Join Date
Oct 2003
Location
Fortaleza - Northeast of Brazil
Posts
12
I'm trying to communicate the Microwin Software to a S7-200 CPU 226
using two Radio Modems, one of them (Master Radio) connected to the RS-232 serial port of my PC, and the other radio (SLAVE) connected to PORT 0 of PLC through RS-232/PPI Multimaster cable. Both radios works in transparent mode.
I need to succeed this communication so that I could make remote downloads/uploads of the PLC user program. When I try this communication, the Tx/Rx leds in the PPI cable blink, but the CPU is not found. Could someone give me a tip about that?
 

Similar Topics

C
SLC 5/03 Communication / Processor Issue
Hello All! I am writing today because I cannot figure this out for the life of me. Another site I am affiliated with keeps having their slc 5/03s...
Replies
10
Views
182
geniusintraining
geniusintraining
A
Communication Issues between PowerFlex 700 and M580 Controller
Hello, I am currently in the final week of my internship and I have encountered issues with communication between a PowerFlex 700 variable...
Replies
0
Views
56
asmer
A
dalporto
ProSoft MVI56E-MNETC Client Communication monitoring
Hi all. I have a Modbus ProSoft module in my setup with a capability of 30 clients (0-29), which I'm trying to monitor the Ethernet Connection...
Replies
0
Views
42
dalporto
dalporto
F
Modbus TCP communication
Hi folks, I have a Controllogix in communication with a zigbee coordinator using Logix AIO for modbus tcp. This zigbee coordinator have 3 slaves...
Replies
10
Views
317
Contr_Conn
Contr_Conn
T
TIA Portal 15.1. and fanuc SR-6iA Communication
Hello, i am using profibus as communication between plc and fanuc arm. I can easily send inputs from plc to arm, but i can't monitor any outputs...
Replies
0
Views
47
Tinx12
T
Back
Top Bottom