Connect GSM Modem to Delta PLC and write AT commands

Yash Sanghvi

Member
Y
Join Date
Apr 2021
Location
Bangalore
Posts
2
I recently purchased a GSM modem model number SGM510 from a local dealer in Mumbai, India and I am trying to connect it to a Delta PLC that I have of model number - AS228T via RS485 port but I'm not able to connect it. The COM1 port in PLC is already connected to different multi function meters , so I'm using COM2 port in the PLC. Main aim is to write AT commands from PLC to GSM modem depending on the conditions given in ladder programming in Delta's software. I'm very new to PLC and automation in general so any help in this regard would be appreciated.
Thank you
 

Similar Topics

Z
SCADA Pack RTU 474, IO card (5606) Not responding in Remote Connect
Hi, We have been facing a issue with SCADAPack 474. Configuration is like below. RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module Only...
Replies
0
Views
41
Zubairjaved786
Z
S
Siemens PLC Main Disconnect Trip
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
Replies
12
Views
332
JesperMP
JesperMP
C
MSG instruction connect failure between ControlLogix5572 and MicroLogix 1400.
I'm using a SLC typed write from the ControlLogix5572 to the MicroLogix 1400, with path: 2, (MicroLogix IP). The ControlLogix equipment has a...
Replies
0
Views
121
Chris3EC
C
P
How to connect to Schneider M241 PLC remotely from EcoStruxure Machine Expert software using SSH tunnelling?
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
143
Para
P
T
HMI shows motor running even though disconnect is on.
Here's what happened, Operator turned on the disconnect for an auger while it was still running to cut power. Auger DID in fact turn off, but the...
Replies
8
Views
365
TheColt46
T
Back
Top Bottom