Hi all.
I have an Omron CPM1 plc and can't get CX programmer to connect to it properly. I've set all the parameters correctly in the PLC properties box and used the auto on-line function. I can connect eventually but it's very slow. It can take a minute to send a ten byte program to the plc or 30 seconds to change from program to monitor made.
Sometimes it comes up with the error "Access rights may have been acquired by another user" When I try to communicate with it.
When I use syswin 3.4 it functions perfectly.
Any ideas?
I have an Omron CPM1 plc and can't get CX programmer to connect to it properly. I've set all the parameters correctly in the PLC properties box and used the auto on-line function. I can connect eventually but it's very slow. It can take a minute to send a ten byte program to the plc or 30 seconds to change from program to monitor made.
Sometimes it comes up with the error "Access rights may have been acquired by another user" When I try to communicate with it.
When I use syswin 3.4 it functions perfectly.
Any ideas?