Tim Ganz
Member
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
ControlLogix Redundancy Module Single Mode Fiber
- Thread starter Tim Ganz
- Start date
Ken Moore
Lifetime Supporting Member
Way back in the day, single mode had much more bandwidth than multi-mode. But, this is no longer the case. But why change something that works.
Similar Topics
Hello,
My associate and I are trying to sync up two ControlLogix racks (7-slot chassis) with identical modules. We are able to see the secondary...
Hello, I have a ControlLogix redundant controller being set up. The program reads a value from a remote site which hosts a SLC PLC. Rockwell...
Hi Guys,
Is it okay to have Redundancy ControlLogix Processor IP address set to DHCP?
I had Static IP address on it but removed it via RSLinx...
Hi Guys,
For a Redundant Controllogix L81E with EN2TR, on a Device Level Ring;
does the Controller also require IP address assigned?
Hey Members,
I hope all of you are doing well , I am using a 1756-l72 redundancy system, communicating RIO on DLR network.
When both my PLC are...
