ControlLogix to Omron CS1 data transfer
- Thread starter automatic
- Start date
gtsuport
Member
How much data do you need to transfer?
I know nothing about ControlLogix, but you may be able to send the data over ethernet to the CF card in the CS1, then read the info from the CF card. The Omron Ethernet card will support FTP.
Just a thought.
I know there are others that check this forum that may be able to offer additional information.
Good Luck!
I know nothing about ControlLogix, but you may be able to send the data over ethernet to the CF card in the CS1, then read the info from the CF card. The Omron Ethernet card will support FTP.
Just a thought.
I know there are others that check this forum that may be able to offer additional information.
Good Luck!
Similar Topics
Hello,
I would like to send 10 Bytes of data from a CJ1M Omron Processor to a ControlLogix PLC.(copy of the Bytes)
Both PLCs have DeviceNet...
Has anyone used the two of these together?
I am able to communicate serially with the RFID reader using my laptop and Omron's demo software. I am...
I'm trying to integrate a Beckhoff IPC with a Controllogix PLC. There is some documentation, on the Beckhoff website, on how to do a PLC-PLC comms...
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Hello,
I have two 16 point input cards and 1 16 point output card showing module faulted on my IO tree in Logix Designer.
The fault code is...
