Cpu 1214c

moggie

Lifetime Supporting Member
M
Join Date
Apr 2002
Location
Devon, England.
Posts
662
I have a siemens CPU 1214C PLC and a Siemens TP900 HMI connected via Ethernet.
The HMI is only for setting up - when I disconnect the HMI the PLC error LED blinks.
Is there anyway of stopping this from happening when the HMI is Disconnected?
 
If the HMI is only configured for HMI functionality, I've never run into that error before.

However, it is possible for the HMI to be set up as a Profinet Device, at which point the PLC would have an error if the HMI is missing.

What errors are listed in the diagnostic buffer of the PLC?
 

Similar Topics

R
FHPP Communication with Siemens CPU 1214C on modbus TCP over 4 Devices.
Hi All, I am trying to communicate siemens PLC with FESTO Servo & 3 Festo make Steppers on FHPP Modbus Protocol. Sometimes, I face Modbus...
Replies
0
Views
1,343
Ramsri
R
C
CPU 1214C, DC/DC/DC, 14DI/10DO/2AI Firmware V4.1
Hi All, I am looking to see if anyone has had this issue before. I have a TIA portal on site which is programmed in TIA Portal V13.0 but the...
Replies
3
Views
3,552
Jeff23spl
J
Z
PLC CPU Unit Upgrade
Hello all, I have a one problem. I would like to upgrade Mitsubishi PLC Q02 to Q03UDVCPU. I have Q02 program and I change to PLC type and try to...
Replies
7
Views
153
parky
P
M
DL205-1 CPU Monitoring
Hello everyone! I need to connect to a DL205-1 CPU and, as far as I know, I need to use DirectSOFT 6 software for the connection. Is anyone...
Replies
1
Views
69
bernie_carlton
bernie_carlton
C
How to Time Sync? S7-400H CPU (Time Master) With Wincc Runtime V7.5(Time Slaves)
hello s7-400h and wincc are connected to each other via Ethernet. I need help on how to do time synchronization
Replies
0
Views
64
Controller5848
C
Back
Top Bottom