JesperMP
Lifetime Supporting Member + Moderator
Thankyou both of you.
I have gone through both these vendors sites, and missed both of them. It just goes to show that it is a bit hard to find stuff. I may have taken the wrong route by going to the application examples 1st and then take the safety relays mentioned in the examples as the ones I would have to use.
I need up to 120 seconds delay, so I cannot use the STI SR223SMT device.
About the PILZ e1vp 300, I can see that there are many possibilities, but I have failed to figure out how to connect it up - my failure I am sure. Why isnt there a complete application example ?
I will continue to look into the matter. Any inputs are still welcome
I have gone through both these vendors sites, and missed both of them. It just goes to show that it is a bit hard to find stuff. I may have taken the wrong route by going to the application examples 1st and then take the safety relays mentioned in the examples as the ones I would have to use.
I need up to 120 seconds delay, so I cannot use the STI SR223SMT device.
About the PILZ e1vp 300, I can see that there are many possibilities, but I have failed to figure out how to connect it up - my failure I am sure. Why isnt there a complete application example ?
I will continue to look into the matter. Any inputs are still welcome